Lytening Shallow AirSeal Convertible (IC/Non-IC)
6 3/4" Aperture
For restricted plenums or shallow ceiling cavaties with 2" x 6" joist construction.
For use in insulated or non-insulated ceilings.
AirSeal for restricted air leakage, complies with the MEC and WSEC energy codes.
Compatible Trims: B17, B17WH, 1178LX, 1177LX
Features- Housing: .032” (#20 ga.) Aluminum. UL listed convertible IC/NON-IC.
2” vertical adjustment in ceiling. Can be removed for access to junction box and ceiling plenum.
5 1/2” tall for use in 2” X 6” joist construction and shallow plenum applications.
AirSeal® housing minimizes air leakage to less than 2 CFM at 1.57 PSF (or 75pa),
which complies with Model Energy Code (Section 602.3.3) and Washington State Energy Code
(Section 502.4) and reduces heat loss and condensation in ceiling. - Mounting Frame: .048” (#18 ga.) galvanized steel. Locks into position along length
of mounting bars with locking spring and bendable slot. (3) slots 90° apart simplify alignment. - Junction Box: 2” X 4” X 3 1/2” (22 cu. in.) .032” (#22 ga.) galvanized steel.
UL listed for maximum of 8 (#12 ga.) 1104SIC/N and 6 (#12 ga.) 1004SIC/N 90°C through branch
circuit conductors. Integral cable clamps permit attachment of non-metallic (#12 or #14 ga.)
Romex® cable without tools or additional connectors. - Mounting Bars: .059” (#16 ga.) galvanized steel. Bars pivot for easy
attachment and
wire-in below ceiling line. Bars extend to accommodate 16” to 24“ O.C. joist spacing.
Bars can accommodate 9” O.C. joist spacing after a slight field modification (See Instruction Sheet).
1104SIC features integral self-tapping phillips screws for secure attachment to wood or metal construction.
The 1104SICN features integral nails for secure attachment to wood.
Both attach to T-bar ceilings without the need of accessories. - Socket Housing: Impact extruded aluminum or galvanized steel.
Attached trim retaining spring secures trim to any height on housing wall. - Socket: Porcelain medium base; nickel plated screw shell.
Pre-wired with #18 ga. SF1 (300 Volt 200° C) leads to junction box. - Thermal Protector: Meets NEC and UL requirements. Located inside housing.
